How to clean and lubricate bearing 688zz?

The skateboard bearing 688zz is not as precise as those of the yo-yo, because there are eight bearings and four middle locks on a board, it is best to replace all eight bearings, no matter which shaft explodes first, this is necessary.

cleaning of bearing 688zz
The cleaning of the skateboard bearing 688zz is very simple. Remove the bearing from the board, wipe off the oil and stains on the bearing with a paper towel, and wipe off the inner wall of the wheel. Changing the wheels on the left, right, front and rear is good for the smoothness of the bearing.

It is cleaned about once a week. The high temperature generated by the rotation of the bearing when using the plate will close the rubber of the wheel to the bearing wall, causing inconvenience when changing the wheel or bearing. Therefore, remove the bearing and install the wheel frequently. To avoid trouble, the bearing 688zz can be cleaned at the same time.

bearing 688zz oiled
After cleaning the bearing 688zz, remember to apply oil. The range of oil is very wide. Cooking oil is all right. However, some people say that the bearings are soaked in gasoline for a week, which is a waste of gasoline. It doesn’t matter if the bearing is oiled. The bearing just bought has lubricating oil to store the oil to prevent bearing 688zz from rusting. When using the plate, the oil can be sent out of the bearing. When cleaning, remove the oil used for the first time. Oiling, because these oils do not have a lubricating effect, it is as simple as a measuring cylinder that cannot be heated but only measures liquid. It only prevents rust, but it is difficult for the plate bearings that are often used to rust.

bearing 688zz rust
Bearing 688zz will rust when it touches water. If you want to continue sliding after passing through the water, the water on the wheels will evaporate very quickly, and it will evaporate after sliding for about 10 meters.

Contact: Miya
Email: [email protected]
Skype: [email protected]
MP/Whatsapp: (86)18363031398
Wechat:18363031368