How to maintain the pillow block bearing housing unit?

Pillow block bearing housing unit should pay special attention to the following points during use:
(1) The use of a cooling block bearing housing unit. Pillow block bearing housing unit not only prolongs the service life of the bearing housing but also improves production efficiency when used correctly. The material of the shaft block bearing housing unit is generally made of special concrete block bearing housing unit steel. The best block block housing housing unit steel also has their limit, such as temperature. Pillow block bearing housing unit In the use state, if the mold temperature is too high, it is easy to cause the crack on the surface of the core early, and some of the pile block bearing housing unit does not even exceed 2000 holes. appear. Even the block block housing housing unit is in production because the temperature of the housing is too high, the core has changed color, and even after measuring more than 400 degrees, such temperature is prone to cracking when the mold release agent is chilled.

Patterns, the products produced are also prone to deformation, strains, sticking molds, etc. In the case of using the cooling block bearing housing unit cooling water, the use of the release agent can be greatly reduced, so that the operator does not use the release agent to lower the temperature of the pillow block housing housing unit. The utility model has the advantages of effectively extending the life of the bearing housing, saving the die casting cycle, improving the product quality, reducing the occurrence of sticking and straining and sticking aluminum, and reducing the use of the releasing agent. It also reduces the loss of the ram and core due to overheating of the pillow block housing housing unit.

(2) The pillow block bearing housing unit must preheat the pillow block bearing housing unit during the start of production to prevent the sudden occurrence of hot metal liquid in the cold pillow block bearing housing unit, resulting in the occurrence of cracks in the turtle. The complex pillow block housing housing unit can use a blowtorch, liquefied gas, and a good mold temperature machine. The relatively simple housing can be preheated by slow injection.

(3) The cleaning of the split pillow block bearing housing unit is very troublesome and easy to ignore. The operator applies kerosene thoroughly to clean the bearing part parting surface, which not only prevents the bearing seat from being blocked. The crushing, and after cleaning, can open the venting groove of the pillow block bearing housing unit which is blocked by the residue of the releasing agent or other dirt, which is favorable for the gas discharge in the cavity during the injection process to improve the product quality.

(4) If the pillow block bearing housing unit is equipped with neutron control, it is absolutely forbidden to link the signal line between the die casting machine and the pillow block bearing housing unit. The reason is very clear. In daily production, it is difficult to avoid the signal line. If the water is wet, or the joint is too easy to break, it will be short-circuited with the machine. If the signal is wrong, the alarm will automatically stop and delay the time, and the signal will be disordered, and the pillow block bearing housing unit will be broken. Cause unnecessary losses. Travel switch attention waterproof